Baldor Tapered Spindle 3/8" Arbor Hole Friction Grip Dental Lathe Polishing "R"

BALDOR TAPERED SPINDLE 3/8″ RIGHT
Fits Baldor POLISHING
LATHE
TAPERED
SPINDLE
FITS BALDOR DENTAL LATHE MOTOR
S
The spindle is made to use with a
Baldor Dental
Polishing motor.
Spindle is fits 3/8″ Polishing
lathes
has an inside
diameter that is tapered to fit on the tapered shaft of a Baldor Dental Polishing
motor. These are specifically made to fit Baldor motor shafts since they are
not straight, but have a slight taper.
Spindles are a friction fit, they
are pushed on to the shaft of the Baldor motor, to properly secure them onto
the shaft, lightly tap with a soft mallet or a piece of wood.
To remove, just use the screw off spindle
remover on the motor by simply unscrewing and turning it
until the spindle is pushed off of the
tapered shaft.
.
Spindles
is made of cold rolled steel is machined to close tolerances, made in U.S.A.
.
Spindle has a 3/8″ Tapered arbor hole to work on the RIGHT
Side of Baldor 3/8″ shaft motors.  
The spindle arbor hole has a slight tapered to fit and be held on
the Baldor Motor Lathes RIGHT Side shaft.
Note: Spindle does not have tightening screws.
.
FEATURES:
·
Precision Quality
·
Machined – High Speed Lathe
·
Made from 3/4″ Stock Material
SPECIFICATIONS:
JETS Product # 1603-112370
·
Material:
Cold Rolled Steel
·
Overall Length:
3-3/8″ – 87mm
·
Spindle Body Length:
1-3/8″ – 35mm
·
Spindle Tapered Length:
2″ – 51mm
·
Arbor Hole
:
3/8″ Tapered Friction Grip to Shaft
·
Weight:
2.75oz.
Spindle is made to be used on a 3/8″ tapered shaft
diameter and on the Right Hand Side of Motor with forward direction.
SHIPPING:  Via USPS FIRST CLASS MAIL
NOTE: Visit
JETSTOOLS
our
ebay Store where you can see listings of various Commercial Grades of Spindles,
Arbors, Miniature Mandrels and Holders along with more
J
ewelers
E
quipment
T
ools and
S
upplies
.
JETS
Inc.
B4 613 CKSP M